No matter what technology is used, to process, there are their own considerations, we need to take into account these issues, so that their own processing, to complete the better, so that there will be no problems as well as trouble, computer gong processing is also the same, then computer gong processing in the programming to consider what problems!
1, carefully analyze the drawings, to determine a reasonable process route.
2, the size of the tool specifications to be selected, and the actual dimensions measured to fill in the tool card.
3、Determine the reasonable cutting dosage. Mainly the spindle speed, back draft, feed rate, etc.
4. Enough space should be left for automatic tool change to avoid collision with the workpiece or fixture. The tool change position is recommended to be set at the origin of the machine tool.
5、For the convenience of checking and debugging program, and the main program mainly completes the tool change and subroutine call. This procedure is simple and clear.
6, the program to be programmed to check and test run, pay attention to whether there is interference between the tool, fixture or workpiece. When checking M, S, T function, it can be done in Z-axis locked state.
